Optional extra Upsell- Leak test

1.Start the car and put the heating on to level three and as five minutes goes on, set it to level four

2.With the general vacuum, hoover the car thoroughly as would do with a normal interior clean

3.Pull out all of the seatbelts from the car due to the mould that is still active

4.With the wet vacuum, thoroughly spray the interior extraction shampoo on the affected areas of the car covering 1 section per time

5.Now with the drill brush, apply firm pressure agitating pressure to the selected portion of the car top to bottom

6.Extract all of the interior extraction and mould that is still remaining by using the wet vacuum with no forum applied agitating and extracting from top to bottom

7.Repeat this process around the whole car

8.With the mats, lay on the floor outside and clean separately, upon drying with the wet vacuum, moving from left to right then instantly in a up and down pattern afterwards

9.Once finished, with the dashboard cleaner, spray down each completed section of the car including the roof with four sprays each to ensure there's no mould left 

9. To remove mould from the windows, hold the pressure washer closer to it and move vertically to flush it out. 

10. Leave the windows slightly cracked to let air inside of the vehicle and prevent potential steaming up allowing the moisture to escape

Key information

*Split the wet vacuum hose head to be able to get into tighter areas if unavailable with full hose applied.

*Ensure that no solution is accidentally applied to the windows due to the hardness of the solution leaving stains.

*When agitating and extracting, it is vital to follow a systematic process either from front to back or side to side

*Excess shampoo cannot be left behind due to the stains left if left unextracted.

N.B For the children seat, you will inform the customer to remove it so we will not be help responsible for damages